{
  "id": "anycubic/vyper",
  "vendor": "Anycubic",
  "model": "Vyper",
  "category": "3d-printer",
  "status": "open-firmware",
  "summary": "Klipper ships a config for this printer (config/printer-anycubic-vyper-2021.cfg); its controller board is flashed with the Klipper firmware (MCU: STM32F103, GD32F103).",
  "projects": [
    {
      "name": "Klipper (printer-anycubic-vyper-2021.cfg)",
      "url": "https://github.com/Klipper3d/klipper/blob/master/config/printer-anycubic-vyper-2021.cfg",
      "kind": "firmware",
      "license": "GPL-3.0"
    },
    {
      "name": "Marlin (example configuration)",
      "url": "https://github.com/MarlinFirmware/Configurations/tree/bugfix-2.1.x/config/examples/AnyCubic/Vyper",
      "kind": "firmware",
      "license": "GPL-3.0"
    }
  ],
  "install": [
    {
      "project": "Klipper",
      "method": "sd-card",
      "guide": "https://www.klipper3d.org/Installation.html",
      "difficulty": "medium",
      "tools": [
        "Raspberry Pi or other Linux computer (runs the Klipper host)",
        "USB cable",
        "microSD card"
      ],
      "brick_risk": "low",
      "reversible": "partial",
      "notes": "Board-specific build and flashing steps are in the header of config/printer-anycubic-vyper-2021.cfg. Going back needs the vendor's stock firmware file, when the vendor publishes it."
    },
    {
      "project": "Marlin",
      "method": "sd-card",
      "guide": "https://marlinfw.org/docs/basics/install.html",
      "difficulty": "medium",
      "tools": [
        "Computer to build Marlin with the example configuration (PlatformIO), unless a pre-built binary exists",
        "microSD card or USB cable"
      ],
      "brick_risk": "low",
      "reversible": "partial",
      "notes": "Most 32-bit boards install firmware.bin from the SD card; 8-bit boards are flashed over USB, and some ship without a bootloader (then an ISP programmer is needed). Going back needs the vendor's stock firmware file, when the vendor publishes it."
    }
  ],
  "provenance": {
    "sources": [
      "klipper",
      "marlin"
    ]
  },
  "updated": "2026-10-17",
  "aliases": [
    "Vyper (2021)"
  ],
  "identifiers": {
    "chips": [
      "STM32F103",
      "GD32F103"
    ]
  },
  "interfaces": [],
  "claims": [],
  "verification": []
}