3D-printer controller board. Klipper ships a pin mapping for it (config/generic-bigtreetech-manta-m8p-v1.0.cfg); its micro-controller runs the Klipper firmware.
One known way to put open firmware or software on this device, easiest first. Each one links to the project's own instructions.
Needs a cable or the command line · Klipper
Board-specific build and flashing steps are in the header of config/generic-bigtreetech-manta-m8p-v1.0.cfg. Going back needs the vendor's stock firmware file, when the vendor publishes it.
No install report yet. · Report how it went
OpenDeviceDB links to each project's own instructions and tools; nothing is flashed from this site. Flashing is at your own risk and may void the warranty.
No live claim. If you start working on this device, claim it so nobody duplicates your work.
No interface documented yet.
| Project | Kind | Origin | License |
|---|---|---|---|
| Klipper (generic-bigtreetech-manta-m8p-v1.0.cfg) | firmware | community | GPL-3.0 |
Not verified. A "verified on hardware" badge requires a replayable test (hardware-replay) run on a real device with a stated firmware version.
AI assistance not stated.
Status and claims as of the build date (2026-10-18). Data licensed CC BY-SA 4.0; imported data keeps its upstream license.